Jay Hydraulic

• Maximum Operating Pressure: Up to 315 bar (approx. 4500 PSI) at ports A, B, and P.

• Maximum Flow Rate: Approximately 100 L/min (depending on the spool type and operating pressure).

• Hydraulic Fluid: Suitable for mineral oils (HL, HLP) and phosphate esters (HFD-R).

• Fluid Temperature Range: -30°C to +80°C.

• Displacement: 50 cc/rev
• Circuit: Load Sensing (LS)
• Relief pressure: ~100–125 bar (typical)
• Ports: BSP / UNF depending on variant
• Flow control: Dynamic LS (0.6–0.9 L/min pilot flow)
• Mounting: 4-bolt steering column mount

• Pressure Range: This specific "10" model is designed for low-pressure monitoring, adjustable from roughly 4 bar to 10 bar.

• Maximum Operating Pressure: The body can withstand up to 100 bar, though the switching range is limited to 10 bar.

• Switching Accuracy: Less than ± 1% of the maximum set pressure.

• Electrical Rating: * AC: 250V / 5A

  • DC: 250V / 0.2A

• Electrical Connection: DIN 43650 (ISO 4400) plug-in connector, often equipped with an LED indicator.

• Fluid Compatibility: Mineral oil (viscosity 10 to 380 cSt).

• Maximum Working Pressure: 700 bar (10,150 psi).

• Flow Capacity: 2.8 $cm^3$ per stroke.

• Force Required: Approximately 385 N (86 lbs) at the end of the lever when at maximum pressure.

• Fluid Compatibility: Mineral-based oils (ISO VG 68 recommended).

• Mass: Approximately 8.6 kg (without oil).

• Outlet Port: G 1/4 (BSPP).

The Polyhydron C06S1-03 is a high-reliability, subplate-mounted check valve (non-return valve) designed for industrial hydraulic systems. Polyhydron components are widely used in India and Southeast Asia, known for being robust "workhorse" valves.

The C06 model is specifically designed to allow free flow in one direction and provide a leak-tight shutoff in the opposite direction.

• Max Operating Pressure: 315 bar (4570 psi).

• Max Flow Rate: Up to 40 L/min (depending on the pressure drop across the valve).

• Cracking Pressure: 0.3 bar. This is the minimum pressure required to push the internal poppet off its seat to allow flow.

• Mounting Interface: Follows ISO 4401-03-02-0-05 (Standard NG6 mounting pattern).

• Hydraulic Fluid: Mineral-based oils (HL, HLP) with a viscosity range of 10 to 500 cSt.